HC05 Bluetooth Transceiver Module with TTL Output
The HC‐05 module is an easy to use Bluetooth Serial Port Protocol module, designed for transparent wireless serial connection setup.
The HC-05 Bluetooth Module can be used in a Master or Slave configuration, making it a great solution for wireless communication.
This serial port Bluetooth module is fully qualified Bluetooth V2.0+EDR (Enhanced Data Rate) 3Mbps Modulation with complete 2.4GHz radio transceiver and baseband.
It uses CSR Bluecore 04‐External single chip Bluetooth system with CMOS technology and with AFH (Adaptive Frequency Hopping Feature).
The Bluetooth module HC-05 is a MASTER/SLAVE module.
By default the factory setting is SLAVE.
The Role of the module (Master or Slave) can be configured only by AT COMMANDS.
The slave modules cannot initiate a connection to another Bluetooth device but can accept connections.
The master module can initiate a connection to other devices.
The user can use it simply for a serial port replacement to establish a connection between MCU and GPS, PC to your embedded project, etc.
HC05 Pin Description
The HC-05 Bluetooth Module has 6pins. They are as follows:
- When enable is pulled LOW, the module is disabled which means the module will not turn on and it fails to communicate. When enable is left open or connected to 3.3V, the module is enabled i.e the module remains on communication also takes place.
- Supply Voltage 3.3V to 5V
- Ground pin
- TXD & RDX:
These two pins acts as a UART interface for communication state:
- It acts as a status indicator. When the module is not connected to / paired with any other Bluetooth device, the signal goes Low. At this low state, the led flashes continuously which denotes that the module is not paired with another device. When this module is connected to/paired with any other Bluetooth device, the signal goes High. At this high state, the led blinks with a constant delay say for example 2s delay which indicates that the module is paired.
- BUTTON SWITCH:
- This is used to switch the module into AT command mode. To enable AT command mode, press the button switch for a second. With the help of AT commands, the user can change the parameters of this module but only when the module is not paired with any other BT device. If the module is connected to any other Bluetooth device, it starts to communicate with that device and fails to work in AT command mode.